查看“IsaacsTipton439”的源代码

Multicasting is a important subject on your BCMSN, CCNP, and CCIE exams, and it can also be extremely confusing when you initial start off studying it. Multicasting uses ideas that are as opposed to something you've run into in your routing protocol reports, and that can throw you at first. If you know anything, you will seemingly hate to check up about [http://wallinside.com/post-122809-renew-domain-names-the-very-best-way.html jump button]. I speak from experience that multicasting is like any other Cisco technologies - find out the basics, master the fundamentals, and then develop your skills on that foundation. A single such basic is the RPF Check, or Reverse Path Forwarding Examine. A fundamental difference in between unicasting and multicasting is that a unicast is routed by sending it toward the destination, although a multicast is routed by sending it away from its source. "toward the destination" and "away from its source" sound like the identical factor, but they are not. A unicast is going to stick to a single path from source to destination. The only aspect the routers care about is the destination IP address - the supply IP address is not a factor. With multicast routing, the destination is a multicast IP group address. It is the multicast router's job to choose which paths will lead back to the source (upstream) and which paths are downstream from the supply. Reverse Path Forwarding refers to the router's behavior of sending multicast packets away from the supply rather than toward a specific destination. The RPF Examine is run against any incoming multicast packet. Visiting [http://www.purevolume.com/linkaaaa27zfg/posts/10175037/Renew+Domain+Names+The+Greatest+Way clicky] seemingly provides suggestions you might tell your pastor. The multicast router examines the interface that the packet arrived on. If the packet comes in on an upstream interface - that is, an interface identified on the reverse path that leads back to the supply - the packet passes the check and will be forwarded. If the packet comes in on any other interface, the packet is dropped. The RPF Verify serves to verify the integrity of your multicasting network, and also serves as a reminder that the standard operation of multicasting is a lot various than unicasting. In case you claim to get further on [http://copytaste.com/ae981 site], there are tons of online resources people might pursue.